Cisco Ccna Exam Questions
cisco certification 200-125 ccna exam preparation with practice questions and Answers
Which process do routers use to determine the subnet network address based upon a given IP address and subnet mask?
binary adding
hexadecimal anding
binary division
binary multiplication
binary ANDing
ccna exploration 1 chapter 6 Exam Question And Answers
Which process do routers use to determine the subnet network address based upon a given IP address and subnet mask?
Newer Post
Older Post
Home
Popular Posts
Refer to the exhibit. Which term correctly identifies the device type that is included in the area B?
source end transfer intermediary
Refer to the exhibit. What two commands will change the next-hop address for the 10.0.0.0/8 network from 172.16.40.2 to 192.168.1.2? (Choose two.)
Refer to the exhibit. What two commands will change the next-hop address for the 10.0.0.0/8 network from 172.16.40.2 to 192.168.1.2? (C...
ccna exploration 1 chapter 5 exam answers
What is a component of a routing table entry? the MAC address of the interface of the router the destination Layer 4 port number the ...
What header address information does a router change in the information it receives from an attached Ethernet interface before information is transmitted out another interface?
only the Layer 2 source address only the Layer 2 destination address only the Layer 3 source address only the Layer 3 destination addres...
A router boots and enters setup mode. What is the reason for this?
The IOS image is corrupt. Cisco IOS is missing from flash memory. The configuration file is missing from NVRAM. The POST process has dete...
Refer to the exhibit. A network administrator has to develop an IP addressing scheme that uses the 192.168.1.0 /24 address space. The network that contains the serial link has already been addressed out of a separate range. Each network will be allocated the same number of host addresses. Which network mask will be appropriate to address the remaining networks?
Refer to the exhibit. A network administrator has to develop an IP addressing scheme that uses the 192.168.1.0 /24 address space. The n...
Refer to the exhibit. While configuring a network, a technician wired each end of a Category 5e cable as shown. Which two statements are true about this setup? (Choose two.)
The cable is suitable for connecting a switch to a router Ethernet port. The cable is suitable for connecting dissimilar types of devices.
Which fiber connector supports full duplex Ethernet?
Third one is the correct Answer
show interface status Cisco command reference basic Cisco configuration
Command : show interfaces status Use In : Privileged EXEC Mode Cisco IOS Command show interfaces status use in switches to view cur...
Refer to the exhibit. A network administrator wants to reduce the size of the routing table of R1. Which partial routing table entry in R1 represents the route summary for R2, without including any additional subnets?
10.0.0.0/16 is subnetted, 1 subnets D 10.5.0.0[90/205891] via 192.168.1.2, S0/0/0 10.0.0.0/24 is subnetted, 4 subnets D 10.5.0.0[90/20...